ITech IT8200 Series

SURGesag Subsystem
Copyright © ITECH Electronic Co., Ltd. 97
Example
SURGesag:PHASe:ENABle ABC
SURGesag:SAVE <string>
This command is used to save this surge/sag file.
Syntax:
SURGesag:SAVE <string>
Example
SURGesag:SAVE "filename"
SURGesag:RECall <string>
This command is used to recall the surge/sag file.
Syntax:
SURGesag:RECall <string>
Example
SURGesag:RECall "filename"
SURGesag:STATe?
This command is used to query the running status of the surge/trap wave.
Syntax:
SURGesag:STATe?
Example
SURGesag:STATe? //Query the running status of the surge/trap wave.