ITech IT8200 Series

Load Protect Subsystem
Copyright © ITECH Electronic Co., Ltd. 57
Arguments
0|1|OFF|ON
Query syntax:
CURRent:PROTection[:LEVel]? [MAXimum|MINimum]
Returns:
0|1|OFF|ON
Example
CURRent:PROTection 90
[SOURce:]CURRent:PROTection:DELay <NRf+>
Set the RMS current protection delay time, the unit is: s
Syntax:
CURRent:PROTection:DELay <NRf+>
Arguments
<MINimum-MAXimum>
Query syntax:
[SOURce:]CURRent:PROTection:DELay?
Returns:
<MINimum-MAXimum>
Example
CURR:PROT:DEL 0.5
CURR:PROT:DEL 10 //设置通道 1 的 RMS 保护延迟为 10s
[SOURce:]CURRent:PEAK:PROTection:STATe <Boolean>
This command is used to set state of over current peak protection.
Syntax:
CURRent:PEAK:PROTection:STATe <Boolean>
Arguments
0|1|OFF|ON
Query syntax:
CURRent:PEAK:PROTection:STATe?