ITech IT8200 Series

Load Protect Subsystem
Copyright © ITECH Electronic Co., Ltd. 59
[SOURce:]POWer:PROTection:STATe <Boolean>
Sets the state of over power protection.
Syntax:
POWer:PROTection:STATe <Boolean>
Arguments
0|1|OFF|ON
Query syntax:
POWer:PROTection:STATe?
Returns:
0|1|OFF|ON
Example
POWer:PROTection:STATe 1
[SOURce:]POWer:PROTection[:LEVel] <NRf+>
The command sets the protection value of power protection, unit: w.
Syntax:
POWer:PROTection[:LEVel] <NRf+>
Arguments
<MINimum-MAXimum>
Query syntax:
POWer:PROTection[:LEVel]? [MAXimum|MINimum]
Returns:
MAXimum|MINimum|DEFault
Example
POWer:PROTection 30
[SOURce:]POWer:PROTection:DELay <NRf+>
Set the power protection delay time, the unit is: s
Syntax:
POWer:PROTection:DELay <NRf+>
Arguments
<MINimum-MAXimum>