ITech IT8200 Series

FETCh & MEASure Subsystem
Copyright © ITECH Electronic Co., Ltd. 37
FETCh[:SCALar]:FREQuency?
MEASure[:SCALar]:FREQuency?
This command is used to read the frequency value.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:FREQuency? [A|B|C]
MEASure[:SCALar]:FREQuency? [A|B|C]
Arguments
[A|B|C]
Returns:
<NRf>…
Example
FETC:FREQ?
FETCh[:SCALar]:POWer[:REAL]?
MEASure[:SCALar]:POWer[:REAL]?
This command is used to read the real power value.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:POWer [:REAL]? [A|B|C]
MEASure[:SCALar]:POWer[:REAL]? [A|B|C]
Arguments
[A|B|C]
Returns:
<NRf>…
Example
FETC:POWer?