ITech IT8200 Series

FETCh & MEASure Subsystem
Copyright © ITECH Electronic Co., Ltd. 34
Example
FETC:CURR:DC?
MEAS:CURR:DC?
FETCh[:SCALar]:CURRent[:AC][:AMPLitude]:MAXimum:POSitive?
MEASure[:SCALar]:CURRent[:AC][:AMPLitude]:MAXimum:POSitive?
This command is used to read the positive peak value of current.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:CURRent[:AC][:AMPLitude]:MAXimum:POSitive?
MEASure[:SCALar]:CURRent[:AC][:AMPLitude]:MAXimum:POSitive?
Arguments
[A|B|C]
Returns:
<NRf>…
Example
FETC:CURR:MAX:POS?
MEAS:CURR:MAX:POS? A
FETCh[:SCALar]:CURRent[:AC][:AMPLitude]:MAXimum:NEGative?
MEASure[:SCALar]:CURRent[:AC][:AMPLitude]:MAXimum:NEGative?
This command is used to read the negative peak value of current.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:CURRent[:AC][:AMPLitude]:MAXimum:NEGative? [A|B|C]
MEASure[:SCALar]: CURRent[:AC][:AMPLitude]:MAXimum:NEGative? [A|B|C]
Arguments
[A|B|C]
Returns:
<NRf>…
Example
FETC:CURR:MAX:NEG?