ITech IT8200 Series

SOURce Subsystem
Copyright © ITECH Electronic Co., Ltd. 68
[SOURce:]CE:PEAK:CURRent <NRf+>[,NRf+][,NRf+]
This command is used to set or query Ipeak value of CE mode.
Syntax:
CE:PEAK:CURRent <NRf+>[,NRf+][,NRf+]
Arguments
MAXimum|MINimum|DEFault
Query syntax:
CE:PEAK:CURRent? [MAXimum|MINimum]
Arguments
MAXimum|MINimum|DEFault
Example：
CE:PEAK:CURRent 30
[SOURce:]CE:TYPE <CPD>
This command is used to select or query CE type.
Syntax:
[SOURce:]CE:TYPE < A|B>
Arguments
A|B
A: Parallel RLC
B: Rectifier single phase RLC
Query syntax:
[SOURce:]CE:TYPE?
Example：
CE:TYPE A
[SOURce:]CE:TA:R <NRf+>[,NRf+][,NRf+]
This command is used to set or query the R set under Parallel RLC, Unit:Ω
Syntax:
[SOURce:]CE:TA:R <NRf+>[,NRf+][,NRf+]
Arguments
<NRf+>[,NRf+][,NRf+]