SWEep Subsystem
Copyright © ITECH Electronic Co., Ltd. 107
Arguments
<NRf+>[,<NRf+>,<NRf+>]
Query syntax:
SWEep:LEVel:STEP? [A|B|C][MAXimum|MINimum]
Returns:
<NR2>
Example
SWEep:LEVel:STEP 1 //set the step value to 1
SWEep:LEVel:STEP?
SWEep:TIME:STEP <NRf+>
This command is used to set and query the single-step execution time of sweep.
It is valid when the mode is TIMe.
<NRf+>: step time setting value, or step time MINimum or MAXimum or DEFault
setting.
Note:
In single-phase (including AC, ACDC, DC, DCAC), there is only one parameter; in
three-phase, three parameters must be taken.
Syntax:
SWEep:TIME:STEP <NRf+>
Arguments
<NRf+>
Query syntax:
SWEep:TIME:STEP? [MAXimum|MINimum]
Returns:
<NR1>
Example
SWEep:TIME:STEP 1
SWEep:TIME:STEP?
SWEep:MODE <mode>
This command is used to set and query the switching mode between the single
steps of the sweep function, and it can be set to TIMe or TRIG mode.
<mode> TIME|TRIG|TIME_LOOP|TRIG_LOOP
TIME_LOOP: Time loop sweep
To Next Page
Loading...