ITech IT8200 Series Programming Guide

FETCh & MEASure Subsystem
Copyright © ITECH Electronic Co., Ltd. 40
FETCh[:SCALar]:VOLTage:DC?
MEASure[:SCALar]:VOLTage:DC?
This command is used to read the DC component of voltage.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:VOLTage:DC? [A|B|C]
MEASure[:SCALar]:VOLTage:DC? [A|B|C]
Arguments
[A|B|C]
Returns:
<NRf> …
Example
FETC:VOLT:DC?
FETCh[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum?
MEASure[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum?
This command is used to read the peak value of voltage.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum?
MEASure[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum?
Arguments
[A|B|C]
Returns:
<NRf>…
Example
FETC:VOLT:AMP:MAX?

ITech IT8200 Series Specifications

General

Brand	ITech
Model	IT8200 Series
Category	Measuring Instruments
Language	English