ITech IT8200 Series

Load Protect Subsystem
Copyright © ITECH Electronic Co., Ltd. 56
Chapter14 Load Protect Subsystem
[SOURce:]PROTection:AUTO:CLEar[:STATe]
<Boolean>
This command is used to set the state of the protection auto-clear function.
Syntax:
PROTection:AUTO:CLEar[:STATe] <Boolean>
Arguments
0|1|OFF|ON
Query syntax:
PROTection:AUTO:CLEar[:STATe]?
Example:
PROT:AUTO:CLE 1
[SOURce:]CURRent:PROTection:STATe <Boolean>
This command is used to set state of over current RMS protection.
Syntax:
CURRent:PROTection:STATe <Boolean>
Arguments
0|1|OFF|ON
Query syntax:
CURRent:PROTection:STATe?
Returns:
0|1|OFF|ON
Example
CURR:PROT:STAT 1
[SOURce:]CURRent:PROTection[:LEVel] <NRf+>
The command sets the protection value of current RMS protection, unit: A.
Syntax:
CURRent:PROTection[:LEVel] <NRf+>