ITech IT8200 Series

SWEep Subsystem
Copyright © ITECH Electronic Co., Ltd. 108
TRIG_LOOP: trigger loop sweep
Syntax:
SWEep:FREQ:STOP <NRf+>[,<NRf+>,<NRf+>]
Arguments
<NRf+>[,<NRf+>,<NRf+>]
Query syntax:
SWEep:MODE?
Returns:
<NR1>
Example
SWEep:MODE TIME
SWEep:WAVeform <name>
Select Sweep waveform.
<name>
<"Sine"|"Square"|"Triangle"|"Saw"|"Trapezoid"|"Clipped-sine"|"DST-01(30)"|"filen
ame">,
<"Sine"|"Square"|"Triangle"|"Saw"|"Trapezoid"|"Clipped-sine"|"DST-01(30)"|"filen
ame">,
<"Sine"|"Square"|"Triangle"|"Saw"|"Trapezoid"|"Clipped-sine"|"DST-01(30)"|"filen
ame">,
Syntax:
SWEep:WAVeform <name>
Arguments
<NRf+>[,<NRf+>,<NRf+>]
Query syntax:
SWEep:WAVeform?
Example
SWEep:WAVeform "Sine"
SWEep:WAVeform:PARameter <NRf+>
This command is used to set and query the waveform parameters (for Example,
the percentage of clipping wave. For waveform types without parameters, this
parameter is invalid).