ITech IT8200 Series

Input Subsystem
Copyright © ITECH Electronic Co., Ltd. 76
INPut:PROTection:WDOG:DELay <time>
This command is used to set software watchdog delay time, unit is s.
Syntax:
INPut:PROTection:WDOG:DELay <time>
Arguments
MINimum|MAXimum
Query syntax:
INPut:PROTection:WDOG:DELay?
Returns:
MINimum|MAXimum
Example
INPut:PROTection:WDOG:DELay 1
INPut:REGulation:SPEed <CPD>
This command is used to set the input regulation speed.
Syntax:
INPut:REGulation:SPEed <CPD>
Arguments
<SLOW|FAST>
Query syntax:
INPut:REGulation:SPEed?
Returns:
<SLOW|FAST>
Example
INPut:REGulation:SPEed SLOW
INPut:OFF:MODE <CPD>
This command is set the connection status when the load is off.
OPENz: disconnect the output relay and the output terminal is in a
high-impedance state.
HIGHz: the output relay is closed and the output terminal is in a high-impedance
state.