ITech IT8200 Series

Input Subsystem
Copyright © ITECH Electronic Co., Ltd. 79
Returns:
MINimum|MAXimum
Example
INPut:OFF:PHASe:LEVel 90
INPut:BALance[:STATe] <Boolean>
In the three-phase mode, it is used to set the state of the input balance mode.
This command is only supported in three-phase mode.
Syntax:
INPut:BALance[:STATe] <Boolean>
Arguments
0|OFF|1|ON
Query syntax:
INPut:BALance[:STATe]?
Returns:
0|1
Example
INPut:BALance ON
INPut:MONitor:PHASe <CPD>
This command is used to set the monitored phase of the input.
This command is only supported in three-phase mode.
Syntax:
INPut:MONitor:PHASe <CPD>
Arguments
A|B|C
Returns:
0|1
Example
INPut:MONitor:PHASe A
INPut:MONitor:VOLTage:RATio <CPD>
This command is used to set the input voltage monitoring ratio.