ITech IT8200 Series

FETCh & MEASure Subsystem
Copyright © ITECH Electronic Co., Ltd. 51
Example
FETC:ARR:VOLT:HARM:DIST? A,6
FETCh[:SCALar]:ARRay:CURRent:HARMonic:DISTort?
<[A|B|C|CH1|CH2|CH3]>,<NR1>
MEASure[:SCALar]:ARRay:CURRent:HARMonic:DISTor
t? <[A|B|C|CH1|CH2|CH3]>,<NR1>
This command is used to measure each harmonic distortion of the current.
Syntax:
FETCh[:SCALar]:ARRay:CURRent:HARMonic:DISTort?
<[A|B|C|CH1|CH2|CH3]>,<NR1>
MEASure[:SCALar]:ARRay:CURRent:HARMonic:DISTort?
<[A|B|C|CH1|CH2|CH3]>,<NR1>
Arguments
<[A|B|C|CH1|CH2|CH3]>,<NR1>
NR1: 0-50
Returns:
<NRf>
Example
FETC:ARR:CURR:HARM:DIST? A,6
VETCor:OEDer <NR1>
This command is used to set and query the order of the vector diagram.
Syntax:
VETCor:OEDer
Arguments
<NR1> range: 0-50
Returns:
<NRf>
Query syntax:
VETC:OED?
Example
VETC:OED 19