ITech IT8200 Series

SCOPe Subsystem
Copyright © ITECH Electronic Co., Ltd. 29
Example
SCOPe:TRIGger:SOURce TRIG1
SCOPe:TRIGger:LEVel <NRf>
This command is used to set and query the trigger level of the oscilloscope.
Syntax
SCOPe:TRIGger:LEVel <NRf>
Argument
[MINimum|MAXimum]
Query syntax
SCOPe:TRIGger:LEVel?
Returns
<NRf>
Example
SCOPe:TRIGger:LEVel MIN
SCOPe:TRIGger:SLOPe <CPD>
This command is used to set and query the trigger edge of the oscilloscope.
Syntax
SCOPe:TRIGger:SLOPe <CPD>
Argument
<RiSE|FALL|BOTH>
Query syntax
SCOPe:TRIGger:SLOPe?
Returns
<RiSE|FALL|BOTH>
Example
SCOPe:TRIGger:SLOPe BOTH
SCOPe:TRIGger:MODE <CPD>
This command is used to set and query the trigger mode of the oscilloscope.
Syntax
SCOPe:TRIGger:MODE <CPD>