ITech IT8200 Series

Input Subsystem
Copyright © ITECH Electronic Co., Ltd. 77
Syntax:
INPut:OFF:MODE <CPD>
Arguments
OPENz|HIGHz
Query syntax:
INPut|OUTPut:OFF:MODE?
Example
INPut:OFF:MODE <CPD>
INPut:ON:PHASe:MODE <CPD>
This command is used to set the mode of phase control when the load input is
turned on.
PHASe: The load starts input with the set phase angle
IMMediate: the load starts input with 0 phase angle.
Syntax:
OUTPut:ON:PHASe:MODE <CPD>
Arguments
PHASe|IMMediate
Query syntax:
INPut:ON:PHASe:MODE?
Returns:
PHASe|IMMediate
Example
OUTP:ON:PHAS:MODE IMM
INPut:ON:PHASe:LEVel <NRf+>
The command sets the starting phase angle value when the instrument input is
turned on.
Syntax:
INPut:ON:PHASe:LEVel <NRf+>
Arguments
MINimum|MAXimum