ITech IT8200 Series Programming Guide

FETCh & MEASure Subsystem
Copyright © ITECH Electronic Co., Ltd. 41
FETCh[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum:POSitive?
MEASure[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum:POSitive?
This command is used to read the positive peak value of voltage.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum:POSitive?
MEASure[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum:POSitive?
Arguments
[A|B|C]
Returns:
<NRf> …
Example
FETC:VOLT:MAX:POS?
FETCh[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum:NEGative?
MEASure[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum:NEGative?
This command is used to read the negative peak value of voltage.
Note: this command parameter is optional. If there is no parameter, it will return
the value of A, B, C three-phase by default.
Syntax:
FETCh[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum:NEGative?
MEASure[:SCALar]:VOLTage[:AC][:AMPLitude]:MAXimum:NEGative?
Arguments
[A|B|C]
Returns:
<NRf> …
Example
FETC:VOLT:MAX:NEG?
FETCh[:SCALar]?
MEASure[:SCALar]?
This command is used to get all METER data.

ITech IT8200 Series Specifications

General

Brand	ITech
Model	IT8200 Series
Category	Measuring Instruments
Language	English