Itotec SC115Z - How to remove the knife (Knife lifter)

5
Start the manual mode.
knife lowers to the bottom. Then release
the cutting buttons.
from the leftmost one appears.
Use the accessaory Allen T wrench to remove
Press the cutting buttons to return the knife
carrier to its original position.
How to change the knife
Move the backgauge to over 200mm position.
Press and hold the cutting buttons until the
The knife carrier is stopped when the cutting
buttons are released, and the second knife bolt
only the second knife bolt from the leftmost.
How to remove the knife (Knife lifter） 1
Remove stacked paper or the like from the surface plate.
Otherwise stacked paper will push out the knife holder or the like
during erroneous backgauge advance in knife change work,
possibly resulting in a broken knife and/or injuries of the operaror.
Leave
knife change to those who have undergone special training
course and observe instruction gives in the instruction manual.
Otherwise injuries will be caused.
Prohibit
approach of a third party near the machine during knife
change or height adjustment work.
Otherwise injuries will be caused.
To
install or remove the knife, prepare necessary tools in advance
and follow the predetermined procedure and be deliberate.
1 .
Keep the main motor operating.
2 .
3 .
4 .
5 .
2 2
1
5 5
4
CAUTION
CAUTION
To work with the knife lowered, stop the
knife with its cutting edge in contact with
the cutting stick.
41