Turn the power switch of main motor off.
Tighten the installation nut to fix.
A limit switch in the holder senses the false clamo to adjust the advance limit of the backgauge
Align the dowel pin of the false clamp with the dowel pin hole of the clamp.
Install/remove the false clamp
Take out the false clamp out of the false clamp holder.
appropriately to the one with the false clamp.
How to Insatall the false clamp
When installing thr false clamp, be careful to keep away the knife in front of the clamp.
Otherwise injuries will be caused.
3
3
4
4
4
Do not install the false clamp while it protrudes beyond the front face of the clamp.
Otherwise contact with the cutting edge will be caused, possibly resulting in damage to
the knife and machine.
CAUTION
CAUTION
2
2
Be sure to stop the main motor when removing or installing the false clamp. If anyone
starts the clamp while another person works at the rear of the machine, injuries will be
caused.
CAUTION
To Next Page
Loading...
