Itotec SC115Z - Page 58

5
Place a cushion such as abook at the Press 【 Clamp stop cancel 】 and reset
Bottom, left and right of the clamp. button ( Black ) of the knife pushbutton
Keep the height identical.
plate simultanously.
The clamp reises.
Select the manual mode.
Pull the false clamp to the front surface
Press 【 Main 】 . plate.
Press the option key. Place on the false clamp installation table
A limit switch in the installation table
Press 【 Remove false clamp 】 .
senses the false clamp to adjust the
advance limit of the backgauge approp-
Press 【 Verification value setting 】 .
riately to the one without the false
Check the counter value ( height from
clamp.
surface plate ). It is 40 to 50mm in
regular cases. Use ▲ or ▼ to adjust. Press 【 Exit 】 .
Press 【 Counter value verification start 】.
Use the clamp pedal, slowly lower the
clamp.
The clamp is stopped at the counter value.
right false clamp installation/removal
holes of the clamp simultanously.
The false clamp comes off the clamp and
drops on the cushion.
Install/remove the false clamp
Front installation/removal setting must be validated with an optinal function setting.
Using the loach handle, press the left and
How to remove the false clamp (Front installation/removal）
1.
2.
3.
10.
4.
5.
6.
9.
When removing the false clamp, be careful
to keep away from the knife in front of
the clamp.
Otherwise injuries will be caused.
7.
8.
11.
12.
５
6
６
９
９
１２
１
１
１
８
８
7
１１
９
CAUTION
58