Johnson Controls SABROE Unisab III Control User Manual

6.5.10 Timer values - screw compressors
214
6.5.11 Timer description - screw compressors
216
6.5.12 Timer values - reciprocating compressors
224
6.5.13 Timer description - reciprocating compressors
225
6.6. Session
230
6.6.1 Password
230
6.6.2 Serial number
230
6.6.3 Remote connect
230
6.6.4 User interface
231
6.6.5 Function interface
232
6.6.6 E-mail
234
6.6.7 Language
235
7. Calibration
236
7.1. Before start-up
236
7.2. Pressure transducers
236
7.3. Temperature sensors (process out tempera-
ture)
238
7.4. Motor
239
7.4.1 Motor frequency signal
239
7.4.2 Motor current
239
7.5. Position transmitters for hydraulic slide sys-
tems (screw compressors)
239
7.5.1 Calibration procedure for position transmitters
240
7.5.2 Capacity slide adjustment, manual Vi
240
7.5.3 Capacity slide adjustment, auto zero point
241
7.5.4 Capacity slide adjustment, auto Vi
241
7.5.5 Volume ratio slide adjustment, auto Vi
242
7.5.6 Adjusting turning transmitter
243
7.5.7 Adjusting long-stroke capacity rod
244
7.5.8 Adjusting long-stroke capacity rod for SAB 283 Mk1
245
7.5.9 Adjusting short-stroke capacity rod for Gram GST, GSV
and RWF and short-stroke volume transmitter for GSV,
RWF and SAB 283 Mk1 and SAB 355 Mk1
245
7.5.10 Adjusting long-stroke capacity rod for SAB 193-233-283
and SAB 355
246
7.5.11 Adjusting short-stroke volume transmitter for SAB
193-233-283 and SAB 355
247
7.5.12 Adjusting short-stroke capacity rod for SAB 120 and SAB
151
247
7.5.13 Software calibration, hydraulic slide systems
248
10/319
Engineering manual - Unisab III 1.10
001930 en 2014.09

Johnson Controls SABROE Unisab III Control Specifications

General

Brand	Johnson Controls
Model	SABROE Unisab III Control
Category	Control Systems
Language	English