Johnson Controls SABROE Unisab III Control User Manual

1.2.10 Factory settings
On delivery Unisab III is preset with factory settings for all appropriate points. Although other
values may have been entered from factory or after delivery, Unisab III can always be reset
to its factory settings. A factory reset affects the following points:
• Alarm and shutdown limits
• Regulator settings
• Timer setup
• Control mode
The factory settings are stated in the tables in the sections Alarms and shutdowns, Timers
and Compressor regulation (Engineering manual). Before performing a factory reset, always
stop the compressor for safety reasons. Select Setup/Configuration/Factory Reset and change
Factory Reset from No to Yes.
Now press
and within a few seconds Unisab III will restart and display the Favourites/De-
fault picture shown in Fig. 1. The reset operation is complete and Unisab III is now restored to
its factory settings. Unisab III must then be adjusted to the actual operating conditions. Re-
member to fill in the forms for actual settings before making a factory reset. These forms
(Settings for Unisab III) are included in the back of this manual.
Unisab III control
Engineering manual - Unisab III 1.10
001930 en 2014.09
35/319

Johnson Controls SABROE Unisab III Control Specifications

General

Brand	Johnson Controls
Model	SABROE Unisab III Control
Category	Control Systems
Language	English