8.5.4 Configuration of Profibus/DP
See subsection 6.4.6. Communication for the software set-up of the Profibus/DP port in Uni-
sab III.
First you must enable Profibus communication by setting Profibus to Yes. Next, define the Pro-
fibus Node No. between 1 and 254 and the protocol type or GSD file no. you want to run. GSD
file 095D is the extended protocol and 08AA is the tiny protocol. The communication speed
Profi baud rate will be set up automatically when Unisab III is connected to another
Profibus/DP device.
For more information see the Unisab Profibus DP protocol manual.
Unisab III (boot) and communication set-up
266/319
Engineering manual - Unisab III 1.10
001930 en 2014.09
To Next Page
Loading...
