6.4.10 R000
See section 3.5. Compressor control - user functions.
6.4.11 Calibration
See chapter 7. Calibration.
6.4.12 Quick Setup
The Quick Setup menu is intended for Unisab III commissioning.
All configuration parameters that initiate a software reset or a software restart are collected in
this Quick Setup menu. In this menu you can change all parameters to the wanted setting
with a and first when you leave the menu by pressing the parameters are changed and
a software restart is performed. Depending on which parameters have been changed a soft-
ware reset to factory settings may also be performed.
Set-up
204/319
Engineering manual - Unisab III 1.10
001930 en 2014.09
To Next Page
Loading...
