Johnson Controls SABROE Unisab III Control - 7. Calibration; 7.1. Before start-up

6.6.6 E-mail
In the picture Session/E-mail you can display the information in the set-up file EmailSer-
vice.xml.
To change the e-mail parameters in the EmailService.xml file you must edit the file with the U
Set configuration tool, see subsection 8.8.1. It is also possible to use an editor such as Word-
Pad. Upload to Unisab III and restart Unisab III. The content in the EmailService.xml file is as
follows:
Remote monitoring e-mail set-up information:
<ToServ_R Val="radar@jci.radarconnect.com" Typ="string"
Def="radar@jci.radarconnect.com"/>
<MailServ_R Val="pasmtp.tele.dk" Typ="string" Def="pasmtp.tele.dk"/>
<ServLogin_RVal="radar@radarconnect.com"Typ="string"Def="radar@radarconnect.com"/>
<ServPW_R Val="radar" Typ="string" Def="radar"/>
User e-mail set-up information:
<ToU1 Val="" Typ="string" />
<ToU2 Val="" Typ="string" />
<ToU3 Val="" Typ="string" />
<ToU4 Val="" Typ="string" />
<MailServ_U Val="pasmtp.tele.dk" Typ="string" Def="pasmtp.tele.dk" />
<ServLogin_U Val="" Typ="string" />
<ServPW_U Val="" Typ="string" />
Unisab III e-mail information:
<SendAdr Val="unisabIII@jci.com" Typ="string" Def="unisabIII@jci.com" />
<SiteName Val="Holme" Typ="string" />
<DevName Val="Compr1" Typ="string" />
Trend:
<ParamList Val="536870911" Typ="int" />
Set-up
234/319
Engineering manual - Unisab III 1.10
001930 en 2014.09