EasyManuals Logo

Johnson Controls SABROE Unisab III Control User Manual

Johnson Controls SABROE Unisab III Control
322 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #162 background imageLoading...
Page #162 background image
Zero capacity position (screws)
The current calculated value of the zero point and any manual setting value of the zero point
are shown in this picture:
For information about Zero capacity Position see also section 3.8.
COP
Unisab III can be set to measure the compressor COP values (Coefficient of Performance) as
well as the mechanical efficiency and the Carnot efficiency. The calculated COP values and a
number of intermediate calculations are shown in this picture:
A more comprehensive description of the COP function and the setting of this can be found in
the manual Unisab III-COP.
Proficom (for internal use only)
This picture shows how Unisab III communicates with other equipment using Profibus com-
munication.
Service
160/319
Engineering manual - Unisab III 1.10
001930 en 2014.09

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Johnson Controls SABROE Unisab III Control and is the answer not in the manual?

Johnson Controls SABROE Unisab III Control Specifications

General IconGeneral
BrandJohnson Controls
ModelSABROE Unisab III Control
CategoryControl Systems
LanguageEnglish

Related product manuals