Johnson Controls SABROE Unisab III Control User Manual

Misc. functions
This picture includes five items:
Suction Ramp Load shows the state of the suction ramp function. See subsection
3.2.3. Special limiters, Suction ramp.
The value shows the actual suction pressure limit which will be equal to the suction pressure
set point if the suction ramp is not active. When the suction ramp is active, the value will de-
crease by 1°C every N seconds, where N is the selected value of the Suct. Ramp timer.
Suction Superheat is the same as suction superheat set point 2 used by the High Discharge
Pipe Temperature Limiter. See subsection 3.2.3. Special limiters.
Capacity and Brake Delay are explained in subsection 3.9.1. Electrical slide control.
LAN load high is used in case the Unisab III interface becomes very slow, or, in the more
extreme cases, if Unisab III restarts when connected to LAN. Changing the parameter LAN
load high from the default setting No to Yes will lower the communication impact on Unisab
III. See also subsection 8.4.2. Ethernet, IP address set-up.
Supervisor password
In this picture, all supervisor password applications including date and hour are registered.
Examine all parameters
In this picture all parameters in Unisab III can be inspected. Use and to inspect the list.
Service
162/319
Engineering manual - Unisab III 1.10
001930 en 2014.09

Johnson Controls SABROE Unisab III Control Specifications

General

Brand	Johnson Controls
Model	SABROE Unisab III Control
Category	Control Systems
Language	English