5: Profi node no.
1 to 254
If Unisab III should communicate with a PLC (Profibus = Yes), select node number which is
different from the node numbers of the PLC.
6: Profi baud rate
When Profibus = Yes is set, Unisab III will set the Profibus baud rate to the baud rate set in
the PLC system. If the profibus communication is not established, the baud rate will show in-
valid index.
7: GSD file no.
08AA (Tiny protocol)
095D (Extended protocol)
When Profibus = Yes has been selected Profibus can be applied in two different ways:
If selecting 08AA, the transmission of signals between Unisab III and the PLC is limited to 16
Integers. This involves 26 possible signals from Unisab III to the PLC and 14 possible signals
from PLC to Unisab III.
If selecting 095D, all available parameters and signals can be transmitted between Unisab III
and PLC. Please note that the GSD file in the PLC must have the same GSD file number as
configured in Unisab III.
For further information, see the dedicated Profibus manual for Tiny or Extended protocol. You
can also find Profibus documentation and examples on www.sabroe.com/products. For access
to the product area you need to log in.
8: Evolution
Yes
No
Select Yes when the Modbus RTU port is used for Evolution communication with a PLC. This
Evolution protocol is proprietary and dedicated to this internal use.
Select No in all other cases.
Dig in via Profibus
Dig. input 1 - 11 Profi
Yes
No
When selecting Profibus = Yes, it can be selected whether the digital inputs should receive
control signals from the terminals in the print cassette (No = default) or from the Profibus
communication (Yes).
Set-up
Engineering manual - Unisab III 1.10
001930 en 2014.09
199/319
To Next Page
Loading...
Need help?
General
