It is not necessary to change the broadcast address. When all settings are OK press and /
Escape. Unisab III will now be restarted with the new settings.
If the communication load on the Intranet/LAN, which Unisab III is directly connected to, is
very high, the user interface may become very slow or in more extreme cases, Unisab III may
restart. If this happens, you can lower the impact of the high communication load on Unisab
III by changing the parameter LAN load high from No to Yes. See also subsection 5.2.2. Soft-
ware, Misc functions.
Unisab III (boot) and communication set-up
260/319
Engineering manual - Unisab III 1.10
001930 en 2014.09
To Next Page
Loading...
Need help?
General
