Find the file you want to upload using the Open button and then press Upload.
The following types of files can be uploaded:
• ColdfireHMI.strip - (program application, not visible in the file overview)
• ResourceBundles – (language file library)
o RessourceBundle - (English language file)
o RessourceBundle_xx - (language file for xx language)
• ArialUnicode_8p.pbf - (Unicode language support file)
• ArialUnicodeBold_8p.pbf - (Unicode language support file)
• UniqueConfig.xml - (configuration file, version info, IP setup)
• HMIsettings.xml - (configuration file, favourites setup)
• Configuration.xml - (configuration file, configuration setup )
• AnalogInput.xml - (configuration file, analogue limits setup)
• PIDSettings.xml - (configuration file, PID parameter setup)
• Timers.xml - (configuration file, timer setup)
• R000Table.xml - (configuration file, refrigerant R000 setup)
• Modbus.xml - (Modbus TCP address look up file)
• EmailService.xml – (configuration file, remote monitor server and user e-mail address
setup)
The following files are for internal use only, do not try to open or modify these files as it may
crash the system.
• ShutdownLog.xml - (for internal use only, do not modify)
• TimeLog.xml - (for internal use only, do not modify)
• Vfd.dat - (for internal use only, do not modify)
• Watchdog.log - (for internal use only, do not modify)
• Flashload.sem - (for internal use only, do not modify)
• trend.txt – (trend log for internal use, do not modify)
• trend.tmp - (trend log for internal use, do not modify)
Make sure to upload language files of the type ResourceBundles_xx into the sub-directory
named ResourceBundles, i.e. you must change the directory (by clicking on ResourceBundles)
before uploading.
Unisab III (boot) and communication set-up
268/319
Engineering manual - Unisab III 1.10
001930 en 2014.09