Starting screw compressor/prelubric ation in AUTO mode, continued
At compres sor start-up the light
diode on front will fla sh gre en .
Check that input
Starting request feed -
bac k
, terminals (X3/19-20), is closed.
Digital input diode no. 5 is on . Can a ls o
be chec ked in picture
Se rvice/Diagnos is/
Hardware /Digital input/PMS feedbac k
= 1.
Check that
Se tup/Configuration/
Oil system/Oil pump = Ye s
.
Oil pump
start s?
Error mes -
sage in oil
system ?
PMS
error mes-
sage re-
ceived?
Try a gain
Input
closed?
Apply jumper, or chec k co n-
nections from termina ls
(X12/17-18) to power man -
agement system.
Check wiring conne ction
to oil float. When float/
level s witch has been
activa ted, digital input di-
ode no. 5 will turn on.
Connection
OK?
Correct wiring
connect.
Che ck floa t/level
switch function
Connec tion
OK?
Correct wiring
connection
Check conne ction from terminals (X12/
3-4) to oil pump motor s tarter
Check if feedba ck is received on te rmi-
nals (X3/3-4) from pump motor gua rd.
Digital inp ut diode no. 2 is on
Connection
OK?
Correct wiring
connect.
Che ck pre-fuse s and control voltage of
pump mo tor guard.
6
No
Yes
No
Yes
7
No
Yes
Yes
No
No
Yes
YesNo
No
Yes
Yes
No
Digital output
Prelub pum p is
activat ed.
Digital output diode
no. 2
is on?
Fig. 54: Error diagram no. 7
Troubleshooting
Engineering manual - Unisab III 1.10
001930 en 2014.09
293/319
To Next Page
Loading...
Need help?
General
