Switch between the password levels with the and keys. When you have selected the ap-
propriate level with the key, you must enter in this case the four digit Superuser password
using the arrow keys.
When you have entered the four digits, press and
F3
/OK.
If the password is accepted, you are now back in the Suction pressure limits picture and may
change the Low shutdown limit with the and keys.
When you have set the limit value, press to store the value in the memory. Before press-
ing you have the possibility to undo the parameter change by pressing instead of . By
doing so, the changes you have just made will not be stored in the memory.
Unisab III control
30/319
Engineering manual - Unisab III 1.10
001930 en 2014.09