the emergency stop during operation will lead to immediate unloading of the motor guard
while there is still power on Unisab III. Therefore, it is always possible to read the compressor
state.
Whenever the emergency stop is activated during operation, the alarm text Compr. motor er-
ror will appear in the display. Before the compressor can be restarted, deactivate the alarm
by means of the
F4
/RESET key and release the emergency stop.
Please note: If Unisab III is set at Remote or Auto, the compressor will restart automatically.
Technical data
Power supply: Nominal VAC Tolerance Hz
85-250 47-63
Consumption: 32 VA
Ambient temperature: 0-55°C (during operation)
Humidity: 10-90% relative humidity (not condensing)
Tightness: IP 54
Engineering manual - Unisab III 1.10
001930 en 2014.09
3/319
To Next Page
Loading...
Need help?
General
