Johnson Controls SABROE Unisab III Control - Page 9

3.3.14 GST with oil pump
103
3.3.15 SAB 283 Mk1, SAB 330 and SAB 355 Mk1 with oil pump
104
3.3.16 SAB 120 and 151 with oil pump
105
3.3.17 SAB 120 and 151 without oil pump
107
3.3.18 SAB 193, 233, 283 and 355 with oil pump
108
3.3.19 SAB 193, 233, 283 and 355 without oil pump
109
3.3.20 SABCube 109, 133 and 159
110
3.3.21 SAB 157HR
111
3.3.22 SABflex
113
3.3.23 Oil charging, manual (screw compressors)
114
3.3.24 Rotatune (VSD)
115
3.3.25 Oil heating
116
3.4. Compressor control - reciprocating compres-
sors
117
3.4.1 Start sequence
117
3.4.2 Oil return
117
3.4.3 Start unloading system for TCMO 28 compressor
117
3.4.4 Additional steps on SMC compressors
117
3.4.5 Oil heating
118
3.4.6 Rota (VSD)
118
3.5. Compressor control - user functions
123
3.5.1 External starting permission - immediate stop
123
3.5.2 External starting permission - normal stop
123
3.5.3 Capacity down blocked
123
3.5.4 Power management system (PMS)
123
3.5.5 Cold store function
123
3.5.6 Aux. output
124
3.5.7 User input
126
3.5.8 Motor current measuring
127
3.5.9 Motor power measuring
127
3.5.10 Thermistor connection
128
3.5.11 COP set-up
128
3.5.12 HP on two-stage
128
3.5.13 Refrigerant R000
129
3.6. Compressor control - chiller functions
129
3.6.1 Oil return from oil separator (ChillPAC)
130
3.6.2 Oil return from evaporator (ChillPAC/PAC)
130
3.6.3 By-pass function (ChillPAC)
130
3.6.4 Flow evaporator (ChillPAC/PAC)
130
Engineering manual - Unisab III 1.10
001930 en 2014.09
7/319