Juniper PTX10001-36MR - Power off the PTX10001-36 MR

10. Enable the Telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a PTX10001-36MR through Telnet by
using root credenals. Root login is allowed only for SSH access.
11. Commit the conguraon to acvate it on the device.
[edit]
root@# commit
RELATED DOCUMENTATION
PTX10001-36MR Management Cable Specicaons and Pinouts | 70
Power O the PTX10001-36MR
IN THIS SECTION
Power O the AC-Powered PTX10001-36MR | 101
Power O the DC-Powered PTX10001-36MR | 102
• Ensure that you have taken the necessary precauons to prevent electrostac discharge (ESD)
damage. See "Prevenon of Electrostac Discharge Damage" on page 173.
• Ensure you do not need to route trac through the PTX10001-36MR.
• Ensure you have the following parts and tools available to power o the PTX10001-36MR:
• An ESD grounding strap
100