Juniper PTX10001-36MR - Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion

The opcal interface must meet the requirement FT-1435-CORE in Generic Requirements for Mul-
Fiber Opcal Connectors . The module must pass the wiggle test dened by IEC 62150-3.
LC Duplex Connectors
You can use patch cables with LC duplex connectors to connect two supported transceivers of the same
type—for example, 40GBASE-LR4-to-40GBASE-LR4 or 100GBASE-LR4-to100GBASE-LR4. The patch
cable is one ber pair with two LC duplex connectors at opposite ends. LC duplex connectors are also
used with 12-ber ribbon breakout cables, as described in "12-Fiber Ribbon Breakout Cables with MPO-
to-LC Duplex Connectors" on page 62.
Figure 22 on page 66 shows an LC duplex connector being installed in a transceiver.
Figure 22: LC Duplex Connector
Fiber-Opc Cable Signal Loss, Aenuaon, and Dispersion
IN THIS SECTION
Signal Loss in Mulmode and Single-Mode Fiber-Opc Cable | 67
Aenuaon and Dispersion in Fiber-Opc Cable | 67
66