Juniper PTX10001-36MR - PTX10001-36 MR Network Port Leds

NOTE: The list of ports supported in Table 4 on page 13 correspond to 3 logical PICs. For
example, for port number 4 listed in the table, there are actually three ports numbered 4 on the
PTX10001-36MR (one on each logical PIC) and all three ports support the same speeds.
Table 4: QSFP28 Ports: Supported for 10-Gbps, 25-Gbps, or 40-Gbps Port Speeds
Port Speed Supported Port Number Corresponding Port Number That Must Be Powerd O
40 Gbps 4 5
6 7
25 Gbps 4 5
6 7
10 Gbps 4 5
6 7
PTX10001-36MR Network Port LEDs
Each PTX10001-36MR network port uses a single bicolored LED to indicate link status, acvity on the
link, or a fault condion. The LEDs for the QSFP28 ports are located above the ports. The LEDs for the
QSFP56-DD ports are located to the le of the ports. Figure 5 on page 14 shows the locaon of the
LEDs.
13