Juniper PTX10001-36MR - Maintain the PTX10001-36 MR Transceivers and Fiber-Optic Cables

NOTE: Each power supply must be connected to a dedicated power source outlet.
NOTE: If you have a Juniper Care service contract, register any addion, change, or upgrade of
hardware components at hps://www.juniper.net/customers/support/tools/updateinstallbase/ .
Failure to do so can result in signicant delays if you need replacement parts. This note does not
apply if you replace exisng components with the same type of component.
RELATED DOCUMENTATION
PTX10001-36MR Power System | 25
Connect the PTX10001-36MR to Power | 85
Maintain the PTX10001-36MR Transceivers and
Fiber-Opc Cables
IN THIS SECTION
Remove a QSFP28 or QSFP56-DD Transceiver | 115
Install a QSFP28 or QSFP56-DD Transceiver | 116
Remove a Transceiver | 117
Install a Transceiver | 119
Disconnect a Fiber-Opc Cable from the PTX10001-36MR | 122
Connect a Fiber-Opc Cable to the PTX10001-36MR | 123
Maintain Fiber-Opc Cables in the PTX10001-36MR | 124
The transceivers for the PTX10001-36MR router are hot-removable and hot-insertable eld-replaceable
units (FRUs). You can remove and replace them without powering o the device or disrupng device
funcons.
114