Juniper PTX10001-36MR - Power off the AC-Powered PTX10001-36 MR

• An external management device such as a PC
• An RJ-45 to DB-9 rollover cable to connect the external management device to the console port
Power O the AC-Powered PTX10001-36MR
1. Connect to the router by using one of the following methods:
• Connect a management device to the console (COM/ToD) port on a PTX10001-36MR by
following the instrucons in "Connect the PTX10001-36MR to a Management Console" on page
96.
• Connect a management device to the management (MGMT) port by following the instrucons in
"Connect the PTX10001-36MR to a Management Ethernet Device" on page 95.
2. Shut down Junos OS Evolved from the external management device by issuing the request system halt
operaonal mode CLI command. This command shuts down Junos OS Evolved gracefully and
preserves system state informaon. A message appears on the console, conrming that the operang
system has halted.
user@host> request system halt
Halt the system ? [yes,no] (no) yes
You see the following output (or something similar) aer entering the command:
System going down IMMEDIATELY
*** System shutdown message from user@host***
halt the system at Thu Jun 20 04:57:23 2019
user@host> Connection to host closed by remote host.
Connection to host closed.
CAUTION: The nal output of any version of the request system halt command is the
"The operang system has halted." Although trac and the operang system have
stopped, the PTX10001-36MR power supply LEDs remain lit and a fan module
101