Juniper PTX10001-36MR - Maintain the PTX10001-36 MR Power Supplies; Remove the AC;HVDC Power Supply from the PTX10001-36 MR

Maintain the PTX10001-36MR Power Supplies
IN THIS SECTION
Remove the AC/HVDC Power Supply from the PTX10001-36MR | 108
Install the AC/HVDC Power Supply in the PTX10001-36MR | 110
Remove the DC Power Supply from the PTX10001-36MR | 111
Install the DC Power Supply in the PTX10001-36MR | 113
The power supplies in a PTX10001-36MR are hot-removable and hot-insertable eld-replaceable units;
You can remove and replace them without powering o the PTX10001-36MR or disrupng roung
funcons.
CAUTION: Do not mix AC/HVDC and DC power supplies in the same chassis.
Here are the parts and tools you’ll need to replace a power supply:
• ESD grounding strap (provided)
• Anstac bag or an anstac mat (not provided)
• (For a DC power supply) Phillips (+) screwdriver, number 2 (not provided)
Remove the AC/HVDC Power Supply from the PTX10001-36MR
WARNING: Turn o the power source before disconnecng the power cord to prevent
damage to the power connector contact.
WARNING: If you need to replace all the power supplies installed in your
PTX10001-36MR, you must power o the PTX10001-36MR before removing the
power supplies. See "Power O the PTX10001-36MR" on page 100.
108