Juniper PTX10001-36MR - PTX10001-36 MR Network Cable and Transceiver Planning; Determine Transceiver Support for the PTX10001-36 MR

PTX10001-36MR Network Cable and Transceiver
Planning
IN THIS SECTION
Determine Transceiver Support for the PTX10001-36MR | 58
Cable and Connector Specicaons for MX and PTX Series Devices | 59
Fiber-Opc Cable Signal Loss, Aenuaon, and Dispersion | 66
Calculang Power Budget and Power Margin for Fiber-Opc Cables | 68
Determine Transceiver Support for the PTX10001-36MR
The PTX10001-36MR has 36 network ports. The 12 QSFP28 network ports on the port panel support
QSFP+ and QSFP28 transceivers, direct-aach copper (DAC) cables, acve opcal cables (AOC) , and
DAC breakout cables (DACBO).
The 24 QSFP56-DD network ports on the port panel support QSFP+, QSFP8, QSFP28-DD, and
QSFP56-DD transceivers, direct-aach copper (DAC) cables, acve opcal cables (AOC), and DAC
breakout cables (DACBO).
See "PTX10001-36MR Port Panel" on page 7 for more informaon about the network ports.
You can nd informaon about the pluggable transceivers supported on your Juniper Networks device
by using the Hardware Compability Tool. In addion to transceiver and connector type, the opcal and
cable characteriscs—where applicable—are documented for each transceiver. The Hardware
Compability Tool enables you to search by product, displaying all the transceivers supported on that
device, or category, by interface speed or type. The list of supported transceivers for the
PTX10001-36MR is located at hps://apps.juniper.net/hct/product/?prd=PTX10001-36MR.
CAUTION: The Juniper Networks Technical Assistance Center (JTAC) provides
complete support for Juniper-supplied opcal modules and cables. However, JTAC does
not provide support for third-party opcal modules and cables that are not qualied or
58