Juniper PTX10001-36MR - PTX10001-36 MR Installation Safety Guidelines

6. Inially congure Junos OS Evolved following the instrucons in "Perform the Inial Soware
Conguraon for the PTX10001-36MR" on page 98.
PTX10001-36MR Installaon Safety Guidelines
IN THIS SECTION
General Installaon Safety Guidelines | 77
PTX10001-36MR Chassis Liing Guidelines | 77
Observe the following guidelines before and during PTX10001-36MR
installaon:
General Installaon Safety Guidelines
Before installing or moving the PTX10001-36MR, verify that the intended site meets the specied
power, environmental, and clearance requirements. See the following documentaon:
• "PTX10001-36MR Site Preparaon Checklist" on page 47
• "PTX10001-36MR Clearance Requirements for Airow and Hardware Maintenance" on page 52
• "PTX10001-36MR Rack Requirements" on page 54
• "PTX10001-36MR Cabinet Requirements" on page 56
• "PTX10001-36MR Environmental Requirements and Specicaons" on page 49
• Table 12 on page 30 or Table 18 on page 41
PTX10001-36MR Chassis Liing Guidelines
The weight of a fully loaded PTX10001-36MR is approximately 39.7 lb (18.0 kg). Observe the following
guidelines for liing and moving a PTX10001-36MR:
CAUTION: If you are installing the PTX10001-36MR above 60 in. (152.4 cm) from the
oor, remove the power supplies and fan modules before aempng to install the
device, or ask someone to assist you during the installaon.
77