Juniper PTX10001-36MR - Install the AC;HVDC Power Supply in the PTX10001-36 MR

6. Place one hand under the power supply to support it and slide it completely out of the chassis. Take
care not to touch power supply components, pins, leads, or solder connecons. See Figure 43 on
page 110.
Figure 43: Remove an AC/HVDC Power Supply
7. Place the power supply in the anstac bag or on the anstac mat placed on a at, stable surface.
8. Install a new power supply within two minutes of removing the old one.
Install the AC/HVDC Power Supply in the PTX10001-36MR
CAUTION: Install the power supply within two minute of removal to prevent chassis
overheang. Before removing the power supply, ensure you have a replacement power
supply available.
1. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end
of the strap to the ESD point on the device.
2. If the power supply has protecve plasc wrap, peel and remove the plasc wrap from all four sides
of the power supply.
3. Taking care not to touch power supply components, pins, leads, or solder connecons, remove the
power supply from its bag.
110