Juniper PTX10001-36MR - PTX10001-36 MR Field-Replaceable Units; PTX10001-36 MR Component Redundancy

PTX10001-36MR Field-Replaceable Units
Field-replaceable units (FRUs) are components that you can replace at your site.
Table 1 on page 6 lists the model numbers and CLI output for PTX10001-36MR FRUs.
Table 1: PTX10001-36MR FRUs and Spares
Component Spare Juniper Model Number CLI Output
Chassis JNP10001-36MR
JNP10001-36MR [PTX10001-36MR]
Fan module JNP-FAN2-1RU
JNP10001 Fan Tray, Front to Back
Airflow - AFO
Power supplies JNP-3000W-AC-AFO
AC AFO 3000W PSU
JNP-3000W-DC-AFO
DC AFO 3000W PSU
NOTE: If you have a Juniper Care service contract, register any addion, change, or upgrade of
hardware components at hps://www.juniper.net/customers/support/tools/updateinstallbase/.
Failure to do so can result in signicant delays if you need replacement parts. This note does not
apply if you replace exisng components with the same type of component.
PTX10001-36MR Component Redundancy
The following hardware components provide redundancy on a PTX10001-36MR:
• Power supplies—The PTX10001-36MR has two power supplies. Each power supply provides power
to all components in the device. The two power supplies provide full power redundancy to the
device. If one power supply fails or is removed, the second power supply balances the electrical load
without interrupon. To provide power redundancy to the system, both power supplies must be
installed. Connect power source feed A to one power supply and power source feed B to the second
power supply.
6