Juniper PTX10001-36MR - Console and Tod Port Connector Pinouts for the PTX10001-36 MR

Table 33 on page 72 provides the pinout informaon of the RJ-45 management port connector. An
RJ-45 cable is supplied with the PTX10001-36MR.
Table 33: RJ-45 Management Port Connector Pinouts for the PTX10001-36MR
Pin Signal Descripon
1 TRP1+ Transmit/receive data pair 1
2 TRP1– Transmit/receive data pair 1
3 TRP2+ Transmit/receive data pair 2
4 TRP3+ Transmit/receive data pair 3
5 TRP3– Transmit/receive data pair 3
6 TRP2– Transmit/receive data pair 2
7 TRP4+ Transmit/receive data pair 4
8 TRP4– Transmit/receive data pair 4
Console and ToD Port Connector Pinouts for the PTX10001-36MR
The console port (labeled CON\ToD) is an RS-232 serial interface that uses an RJ-45 connector to
connect to a console management device. The default baud rate for the console port is 9600 baud.
Table 34 on page 73 provides the pinout informaon for the RJ-45 console connector. An RJ-45 cable
and an RJ-45 to DB-9 adapter are supplied with the PTX10001-36MR.
NOTE: If your laptop or PC does not have a DB-9 plug connector pin and you want to connect
your laptop or PC directly to a PTX10001-36MR, use a combinaon of the RJ-45 cable and
72