KEB F6 - Page 274

Parameter Reference
274
© 2024 KEB America, Inc.
Para.
Name
Adr
Motor Type
Setting Options
Num
Range
Units
Default
Pass
Level
Ind.
PM
Min
Max
Imp.
Met.
LL05
SPI
0x0985
-
RW
Tune Activation
-
0
255
-
-
0
Basic
0
-
-
-
-
-
-
OFF
1
Start
2
Tune Active
3
Tune State
-
off
0
USER: Run empty car UP on Inspection
Speed
16
STATUS: Determining encoder pole offset
32
USER: End the run
48
FAILURE: Speeds not correct, verify encoder
PPR/Signal/Mounting
64
STATUS: Motor phasing incorrect, swapping
encoder phases, run the car UP again
80
USER: Did the elevator travel UP?
96
STATUS: Reversing motor direction, run the
car UP again
112
FAILURE: Encoder error detected, verify
encoder PPR/Signal/Mounting
128
FAILURE: Minimum measurement speed not
reached, increase speed, run the car UP again
144
SUCCESS: SPI complete, do Encoder
Synchronization next
160
Cannot start tune because another tune mode
is already active
176
ERROR: Tune Motor with LL01 first
192
LL06
Encoder Pole Position Learn
0x0986
-
RW
Tune Activation
-
0
255
-
-
0
Basic
0
-
-
-
-
-
-
OFF
1
Start
2
Tune Active
3
Tune State
-
off
0
USER: Run empty car UP on Inspection
Speed
16
STATUS: Determining encoder pole offset
32
USER: End the run
48
FAILURE: Speeds not correct, verify encoder
PPR/Signal/Mounting
64
STATUS: Motor current too large, swapping
encoder phases, run the car UP again
80
USER: Did the elevator travel UP?
96
STATUS: Reversing motor direction, run the
car UP again
112
FAILURE: Encoder error detected, verify
encoder PPR/Signal/Mounting
128
FAILURE: Minimum measurement speed not
reached, increase speed, run the car UP again
144
SUCCESS: Encoder Pole Learn complete
160
Cannot start tune because another tune mode
is already active
176
ERROR: Tune Motor with LL01 first
192