6. Engine Removal;In
spection & Installation
6-59
2.
Seal to divide evenly all coated in the right box processing surface（At about 0.3 mm
thickne
ss）.
3.All of the flange bolts lock first diagonal tighten, which in turn lock.
4.
Close box lock bolts crankshaft, exam
ined the output shaft, and shift drum of the drive
shaft rotation is flexible.
1．
2．
3．
4．
5．As shown in figure respectively with
6． his hands on the part about before and
7．after, pressure or so housing.
With the right to knock tongbang ends
about closed box
6
To Next Page
Loading...