KEEWAY 500ATV - Gearshift

5. REMOV
AL OF ENGINE, TRANSMISSION SYSTEM AND GEARSHIFT
5-7
Re
move joint bolt in drive shaft, front
and Rear axle.
Remove front and rear axle, drive shaft and
rear brake disc
Installation
Installation as contradictorily process of
remove
Bolt torque of Front axle(M8)：23-25N·m
Bolt torque of Front axle(M10)：45-50N·m
Bolt torque of Rear axle(M8): 45-50N·m
Bolt torque of Rear axle(M10): 45-50N·m
Bolt torque of Front and Rear drive shaft:
23-25N· m
Gearshift
Disassembly
Re
move
seat
(→2-6)
Re
move
plas
tic cover，gearshift
（→2-7）
Re
move Bolt.
Remove shift of gearshift fixed in engine.
Remove Bolt of Gearshift by fixed in
Bodywork, Remove Gearshift
Installation
Reverse the rem
oval procedure for installation.
Make sure that gearshift is flexible.
In case of any inflexibility, adjust the gearshift
rod to ensure the gear engagement.
5