1
1. BATTERY，CHARGING SYSTEM
11
-7
Check the connector term
inals for loosening, bending,
rust or come-off.
Check the following items of the main cable terminals
of the two rectifier connectors:
Installation:
Reverse the removal procedure for installation.
Note:
Wires, hoses and cables should be routed properly.
( Charpter1)
Regulator/Rectifier
Measure the resistance between the
terminals using a multimeter.
If any of the resistance is not within the specified
value, replace the regulator/rectifier.
NOTE:
If the multimeter reads under 1.4V when the
probes are not connected, replace the multimeter
battery
.
To Next Page
Loading...