To Next Page

To Previous Page

4-40 Keysight B2900 User’s Guide, Edition 5

Front Panel Reference

Result key group

Pressing the Result key displays the following softkeys for displaying the

measurement, limit test, and trace results.

Measure Displays the measurement result. See “Measure Result dialog box” on page 4-40.

Limit Test Displays the limit test result. See “Limit Test Result dialog box” on page 4-41.

Trace Displays the trace result. See “Trace Statistical Result dialog box” on page 4-42.

Measure Result dialog box

This dialog box is used to display the last single (one shot) measurement result

(maximum 100000 data) stored in the data buffer.

This dialog box provides the following GUI for displaying the measurement result.

The result data is shown in the index and data table below the Type field. Also, the

data is plotted in the graph area above the Points fields.

Ch Only on 2-channel models. Channel 1 (Ch 1) or 2 (Ch 2)

This field specifies the channel of the data to display.

Type Type of data to display, AMPS, VOLTS, OHMS, WATTS,

MATH, or TIME

AMPS: Current measurement data

VOLTS: Voltage measurement data

OHMS: Resistance data given by Resistance=Vmeas/Imeas

WATTS: Power data given by Power=VmeasImeas

MATH: Calculation result data of math expression

TIME: Time data

In the above formula, Vmeas is the voltage measurement data,

and Imeas is the current measurement data.

For details on using resistance compensation, see “Resistance

Compensation” on page 6-16.

Points Number of data points.

Keysight Technologies B2900 Series User Manual

Questions and Answers: