Keysight B2900 User’s Guide, Edition 5 5-5
Front Panel Operations
To Use Functions other than Measurement
To Use Functions other than Measurement
This section describes the following miscellaneous operations other than the source
output and measurement functions.
• “To Set Power Line Frequency”
• “To Return to Factory Shipment Condition”
• “To Apply Initial Settings”
• “To Set Beeper”
• “To Set Date and Time”
• “To Perform Self-Test”
• “To Perform Self-Calibration”
• “To Set Operations at Power On”
• “To Display Error Message”
• “To Clear Error Buffer”
• “To Clear Timestamp”
• “To Set Automatic Clear of Timestamp”
• “To Display Firmware Revision”
• “To Display License Information”
• “To Set GPIB Address”
• “To Set Remote Control Command Set”
• “To Set Remote Display Mode”
• “To Save/Recall All Setup Information”
• “To Enable/Disable Media Transfer Protocol for Easy File Access”
• “To Enable/Disable the Function to Restore the Trigger Mode Settings on the
Local State”
• “To Enable/Disable Source/Limit Real Time Update by Using Digit Pointer and
Knob”
To Next Page
Loading...
